Note: The doors don't continue to cycle lock/unlock? I've tried a few times and it doesn't seem to work. (ie, holding the lock button and unlock button on the new key). Followed the steps to program the doors etc, everything goes as according to the instructions, however it doesn't seem to finish or program. I've got the key cut and I've tried programming it. Close and open door to end programming procedure. If you wait too long and the car exits the programming mode then you must start over.Īfter you get the remote to program then continue on with step 10.ġ0. 2) Don’t hold the remote buttons down as long.Īs long as the car is still in programming mode you can keep trying steps 8 and 9 until you complete the programming. 1) Stand outside of the car while you are performing steps 8 and 9. The most common reason for programming failure is because the car didn’t receive a good signal from the remote. On the remote, press the LOCK button for no more than 1 second.ĪT THIS POINT, the locks should cycle by themselves ONE time. On the remote, press and hold the LOCK and the UNLOCK button at the same time for no more than 2 seconds.ĩ. If the door locks do not cycle (lock and unlock) by themselves then the car isn’t in programming mode and you must start over.Ĩ. You will see the door locks cycle by themselves. (Lock, Unlock, Lock, Unlock, Lock, Unlock, Lock, Unlock, Lock, Unlock)Ħ. (Lock, Unlock, Lock, Unlock, Lock, Unlock, Lock, Unlock, Lock, Unlock)ĥ. If you have a master key then you will probably need to perform this procedure more quickly.ġ. If you can not get your car to go into programming mode make sure you are using a master key and not a valet key. If you perform this procedure too slowly your car will not go into programming mode. If the security light comes on after Step 4 STOP the procedure and start over again. The security light will come on and start to blink after Step 6 until the key is programmed. The security light will go off at Step 1. This light will guide you during the programming procedure. To end programming step on brake one time. When it stops blinking your key is programmed (Be patient, it'll happen). The security light will be blinking for this one minute. Press and release the gas pedal one time.ħ. Insert the new key you want to program into the ignition.Ħ. Press and release the brake pedal 6 times.ĥ. Press and release the gas pedal 5 times.ģ. Insert an already programmed master key into the ignition. anyway below is the method that worked for me.ġ. I have a 2002 IS200 i think 2002 + they changed the method i read somewhere. (started to work then would not complete)įound another method in a forum over seas But the method described in the link above didnt really work for me.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |